Search for: All records

ABSTRACT This study investigates linkages between volume change, pore fluid drainage, shear wave velocity, and temperature of soft clays using a thermal triaxial cell equipped with bender elements, a measurement approach that has not been explored widely in past thermo-mechanical studies. Two kaolinite specimens were consolidated mechanically to a normally consolidated state and then subjected to drained and undrained heating-cooling cycles, respectively. After cooling, the specimens were subjected to further mechanical consolidation to evaluate changes in apparent preconsolidation stress. Both specimens showed net contractive thermal strains after a heating-cooling cycle and overconsolidated behavior during mechanical compression immediately after cooling. The shear wave velocity increased during drained heating, but negligible changes were observed during drained cooling, indicating permanent hardening because of thermal consolidation during the heating-cooling cycle. The shear wave velocity decreased during undrained heating because of a reduction in effective stress associated with thermal pressurization of the pore fluid but subsequently increased when drainage was permitted at elevated temperature. The shear wave velocity increased slightly during undrained cooling but decreased when drainage was permitted at room temperature. Net increases in small-strain shear modulus of 17 and 11 % after heating-cooling cycles under drained and undrained (with drainage after reaching stable temperatures) conditions, respectively, provide further evidence to the potential of thermal soil improvement of normally consolidated clays. Transient changes in shear modulus also highlight the importance of considering drainage conditions and corresponding changes in effective stress state during heating-cooling cycles. 

The thermo-mechanical behavior of saturated clays during a heating/cooling cycle is relevant from the perspective of understanding different types of energy geostructures as well as understanding the use of heat for soil improvement. This paper involves a study of the effect of a heating/cooling cycle on the preconsolidation stress of saturated normally consolidated clays. Although many studies have observed a decrease in preconsolidation stress (thermal softening) after heating of overconsolidated soils, fewer studies have investigated changes in preconsolidation stress of normally consolidated soils. Available thermo-elasto-plastic models indicate that a heating-cooling cycle will lead to thermal contraction and an apparent overconsolidation effect for normally consolidated soils (thermal hardening), but inconsistencies in the literature have been observed. This study involves the use of a thermal triaxial cell to first consolidate kaolinite clay to normally consolidated conditions, apply a drained heating or a heating/cooling cycle, followed by mechanical loading to higher mean effective stresses. The tests presented in this study confirm that cooling also induces an apparent overconsolidation effect on the initially normally consolidated clay, but with a preconsolidation stress greater than that expected from the initial virgin consolidation line before heating. The results are a positive finding regarding the possible use of heat to improve the mechanical response of soft clays.